Emptying gascans...

Anything related to the garden railway world that is not catered for in another board
Post Reply
St.Michael

Emptying gascans...

Post by St.Michael » Thu Aug 02, 2012 9:22 pm

Hello everybody.
Here is a simple question that maybe someone out there has an answer to: Is it possible to fill with a gascan untill it gets completely empty :?: I have a lot of "empty" cans, but I think I still hear liquid gas inside when I shake them. I stop using a can when I can´t manage to notice any more gas going in the gastank.. The preassure is of course low in a can that is almost empty.Could that be the reason? But then, gas is heavier than air, so logically the whole content should just drain into the gastank when filling the loco. Shall I throw my old cans away, or is it more gass in them?

User avatar
TonyW
Driver
Driver
Posts: 1357
Joined: Fri May 16, 2008 9:25 am
Location: North Wales
Contact:

Post by TonyW » Thu Aug 02, 2012 11:56 pm

I finish them off to completely empty by using them with my blow lamp.
Tony Willmore
Rhos Helyg Locomotive Works: http://www.rhoshelyg.me.uk
Facebook: https://www.facebook.com/RhosHelygLocoWorks

User avatar
GTB
Driver
Driver
Posts: 1710
Joined: Sat Mar 05, 2011 2:46 pm
Location: Australia

Re: Emptying gascans...

Post by GTB » Fri Aug 03, 2012 10:08 am

St.Michael:73455 wrote:Is it possible to fill with a gascan untill it gets completely empty :?
It depends on the type of can.

The expensive ones for filling gas lighters don't retain much, if any liquid. The cheap ones are designed for camping stoves and have a dip tube with a right angle on the end, so they don't feed liquid into the stove burner. The dip tube prevents all the liquid being fed out when held upside down to fill a loco tank.

I use the cheap camping butane and like Tony W, I use up the remaining gas in a blowtorch that is designed to fit these cans. I've not measured it, but the torch runs for quite a while on an 'empty' can.

Regards,
Graeme

St.Michael

Post by St.Michael » Sat Aug 04, 2012 7:09 am

Thank you for interesting answers :!:
That really explains things for me. Maybe I should buy a blowtorch, what are the using areas for such a tool?
Michael :)

dws

Post by dws » Sat Aug 04, 2012 7:19 pm

St.Michael:73500 wrote:Thank you for interesting answers :!:
That really explains things for me. Maybe I should buy a blowtorch, what are the using areas for such a tool?
Michael :)
I use my blowtorch to burn off the weeds on my garden path.

User avatar
GTB
Driver
Driver
Posts: 1710
Joined: Sat Mar 05, 2011 2:46 pm
Location: Australia

Post by GTB » Sun Aug 05, 2012 6:24 am

St.Michael:73500 wrote:Maybe I should buy a blowtorch, what are the using areas for such a tool?
I use mine in the workshop for soft soldering large parts and for medium size silver brazing work. It can handle brazing a gas tank, but wouldn't be up to doing a boiler.

If you don't have a workshop, visit a camping store and get a small stove that uses these cans. You can use it on the railway to brew the drivers tea on running days..... ;)

Graeme

ps. Here in Oz you can get weedburners that also use these cans, but I've no idea if they are sold in Europe.....

Post Reply

Who is online

Users browsing this forum: No registered users and 8 guests