HELP!!!!! (Again!)

DolwyddelanLightRail · Post by **DolwyddelanLightRail** » Sat Dec 12, 2009 5:44 pm

Seeing that I have lost the little screw thingy for the meths burner for my mamods, does anyone have an idea on what I could use in it's place??

I need to know this quickly as I am up first thing tomorrow to run it with Edrig!

Crackingjob · Post by **Crackingjob** » Sat Dec 12, 2009 5:54 pm

try standing in B&Q and try all the nuts without looking like your a shoplifter

PCLR · Post by **PCLR** » Sat Dec 12, 2009 5:58 pm

why do you need the meths burner for edrig????

SillyBilly · Post by **SillyBilly** » Sat Dec 12, 2009 6:04 pm

If it's the first time you're steaming your Edrig then I'd run it by itself, because otherwise you just increase the risk of you messing up!

PCLR wrote:why do you need the meths burner for edrig????

I think you'll find he said run 'with Edrig'.

DolwyddelanLightRail · Post by **DolwyddelanLightRail** » Sat Dec 12, 2009 7:04 pm

I need the meths burner to finish off the overhaul of H.G.Butler to see if there are any more steam leaks!

(Oh, and the nearest B&Q store is 25 miles away!)

DolwyddelanLightRail · Post by **DolwyddelanLightRail** » Sat Dec 12, 2009 7:26 pm

I think I have solved it, I have attached a little clip thing which shuts tight, allowing it to keep the burner up, I don't have a clue what It'll be like when its going at the speed of a runaway mamod!

I hope for the best!

DLRdan · Post by **DLRdan** » Sat Dec 12, 2009 9:58 pm

Depending on which burner you have its either a 6 or 8 BA nut

DolwyddelanLightRail · Post by **DolwyddelanLightRail** » Sun Dec 13, 2009 9:57 am

I don't have a clue about the nut needed, but all I now is that I got the burner and uprated SV free with the loco when I got it!

Garden Railway Forum

HELP!!!!! (Again!)

HELP!!!!! (Again!)

Who is online