I will echo the comments above.philipy wrote: ↑Sun Dec 18, 2022 1:45 pm Well, for several reasons I've been thinking about moving away from Sketchup. I've had two goes at Fusion 360, yesterday and this morning, with no more success than I had a year or so ago, so I thought I'd try yet again with Tinkercad.
I have spent 2 hours this morning and another 3/4 hour just now, following your excellent Blog tutorial for the Southwold open. So far I have managed to produce the 5 planks and the backing sheet without too much trouble, but that's as far as I can get. I just can't get them to align properly either vertically nor horizontally.
How you and Steve can get to produce the amazing stuff that you do, I simply can't comprehend. I'm not asking for help and advice because if I can't do something this apparently simple then anything more complex is out of the question. I'm just expressing my admiration for you two!
I am still struggling with making a simple brick wall in Tinkercad while following this tutorial, lets just say my efforts are not pretty.
https://www.youtube.com/watch?v=jTiNQbUEOkI