3D Printed Terrier 0-6-0
Posted: Fri Jun 06, 2025 3:18 pm
This is my first post here, so I hope it’s a good one.
I’ve attached (hopefully) an image of an LBSCR Terrier, specifically the variant of Stepney seen in Thomas and Friends.
This model actually began in Roblox Studio, until I decided that it would be a good idea to import it to TinkerCAD for 3D printing. I quickly discovered the issues with exporting from Roblox and ended up rebuilding the model fully in TinkerCAD using the import as a guide.
I’ve now prepared Stepney for printing, as can hopefully be seen below.
Stepney will be printed fully in PLA, as that’s all I have. I’m hoping it will roll nicely, as I’d like to make a motorised version eventually. I have left off some handrails and pipes, since I have no idea how to print those without lots and lots of scaffolding.
I’m yet to print Stepney, as I’ve been rather busy, but when I do I hope to update this.
- Screenshot 2025-03-26 210744.png (577.65 KiB) Viewed 51545 times
This model actually began in Roblox Studio, until I decided that it would be a good idea to import it to TinkerCAD for 3D printing. I quickly discovered the issues with exporting from Roblox and ended up rebuilding the model fully in TinkerCAD using the import as a guide.
I’ve now prepared Stepney for printing, as can hopefully be seen below.
- Screenshot 2025-05-17 113236.png (369.94 KiB) Viewed 51545 times
I’m yet to print Stepney, as I’ve been rather busy, but when I do I hope to update this.