3D Printed Terrier 0-6-0

[GazTheHoneyeater]

This is my first post here, so I hope it’s a good one.

Screenshot 2025-03-26 210744.png (577.65 KiB) Viewed 35982 times

I’ve attached (hopefully) an image of an LBSCR Terrier, specifically the variant of Stepney seen in Thomas and Friends.
This model actually began in Roblox Studio, until I decided that it would be a good idea to import it to TinkerCAD for 3D printing. I quickly discovered the issues with exporting from Roblox and ended up rebuilding the model fully in TinkerCAD using the import as a guide.
I’ve now prepared Stepney for printing, as can hopefully be seen below.

Screenshot 2025-05-17 113236.png (369.94 KiB) Viewed 35982 times

Stepney will be printed fully in PLA, as that’s all I have. I’m hoping it will roll nicely, as I’d like to make a motorised version eventually. I have left off some handrails and pipes, since I have no idea how to print those without lots and lots of scaffolding.
I’m yet to print Stepney, as I’ve been rather busy, but when I do I hope to update this.

[philipy]

Hi Gaz,
Welcome to the forum. That looks very promising, please keep us updated as you print and build it.
You might like to pop over to the Introductions pages and tell us a bit about yourself and your plans?