Page 1 of 1
mamod saddle tank
Posted: Sun Apr 12, 2015 4:41 pm
by Roberts wood light railwa
picked up a mamod saddle tank yesterday and then went off to roy wood to get a uprated safety valve and water top up valve only to realise they both cant be in at once so i will be using only the uprated safety valve to get the extra bit of power. a lovely looking loco which will fit in just nicely with my line and stock
Posted: Mon Apr 13, 2015 5:57 am
by Chris Cairns
See here for how I got the plugged rear boiler bushing working -
http://gardenrails.myfreeforum.org/about279.html
This Topic also has some horror stories regarding the poor quality of the MSS Saddle Tank loco with an incredible amount of work required to get it running properly -
http://modelsteam.myfreeforum.org/MSS_M ... 80905.html
Chris Cairns
Posted: Mon Apr 13, 2015 7:46 pm
by Roberts wood light railwa
mines fine just a slight leak around the cylinder
Posted: Wed Apr 15, 2015 2:36 pm
by Chris Cairns
Good to read that yours is a runner OK.
The leak around your cylinders should reduce as you run in the loco.
Chris Cairns