Do you have a problem? Here is the place to appeal for help
-
Si
- Trainee Fireman
- Posts: 116
- Joined: Mon Sep 03, 2012 10:26 am
Post
by Si » Fri Jan 04, 2013 3:45 pm
just wondering what we think is the best size of screw for fixing down Peco O gauge track? It will be sat on roofing felt which will be on top of decking boards.
Looked in the DIY shop and the smallest they had were 4g x 20mm which are probably OK length-wise but I wonder if they are a little too thick?
And of course, the most important question - where can I get the recommended screws on the cheap?
thanks
-
Peter Butler
- Driver
- Posts: 5253
- Joined: Sun Sep 09, 2012 10:33 pm
- Location: West Wales
Post
by Peter Butler » Fri Jan 04, 2013 3:53 pm
Unless you use solid brass screws (not plated) I would not bother with screws at all. Steel screws will rust very quickly and become impossible to remove, so you might just as well use pins.
As for cost....there is no such thing as cheap brass anything.
-
MDLR
- Driver
- Posts: 4027
- Joined: Thu Jan 15, 2009 10:38 pm
- Location: Near Ripley, Derbyshire, UK
-
Contact:
Post
by MDLR » Fri Jan 04, 2013 4:37 pm
I used to use 1" No 6 round headed brass screws - available from Screwfix AND there's a good bit of "meat" on the head for when you want to get 'em out again!
-
Si
- Trainee Fireman
- Posts: 116
- Joined: Mon Sep 03, 2012 10:26 am
Post
by Si » Sat Jan 05, 2013 9:26 am
thanks.
-
bazzer42
- Driver
- Posts: 1215
- Joined: Sun Nov 25, 2012 1:37 pm
- Location: Forest of Dean
Post
by bazzer42 » Sat Jan 05, 2013 10:17 am
Another alternative is screwfix stainless steel security fixings. Brass screws maybe dear but brass track even more so, not sure it would stop a determined thief but certainly stop a passing chancer
Bazzer42
Who is online
Users browsing this forum: No registered users and 2 guests