Page 117 of 169

Re: Time to build a railway...but where?

Posted: Tue Jun 23, 2020 4:14 pm
by Andrew
I like that very much!

I'm also tempted to have a go at emulating it at some point - a gradually collapsing farm building would look just right next to my line, I think...

It must have been tricky to get the two halves of the sagging roof to meet in the middle - complex geometry or trial and error?

Cheers,

Andrew

Re: Time to build a railway...but where?

Posted: Tue Jun 23, 2020 4:39 pm
by Peter Butler
Andrew wrote: Tue Jun 23, 2020 4:14 pm

It must have been tricky to get the two halves of the sagging roof to meet in the middle - complex geometry or trial and error?



Andrew
Thanks Andrew,
just trial and error.... I don't do complex!
In reality not too difficult at all as the plastikard is easy to bend into shape and welds together quickly to form a strong joint. Once one side is positioned the second can be scribed against it. It is also well braced inside to give additional support.

Re: Time to build a railway...but where?

Posted: Tue Jul 14, 2020 9:28 pm
by Peter Butler
These days I don't go to too much trouble to add interior detail to carriages I build, generally they would be too far away, or at an inconvenient height, to inspect closely. I always fit seating, and a few passengers as required, to make them look used, but little else.
But.... thirty years ago, when I was out on the exhibition circuit, things were different. Layouts were close enough to the audience so that people could inspect everything, and they expected to see fully fitted interiors, particularly in this scale.
I have just decided to make alterations to one of my early vehicles which required removal of the fixed roof.....
IMG_3671.JPG
IMG_3671.JPG (160.09 KiB) Viewed 5527 times
IMG_3672.JPG
IMG_3672.JPG (152.17 KiB) Viewed 5527 times
IMG_3673.JPG
IMG_3673.JPG (125.32 KiB) Viewed 5527 times
As you can see, the roof has warped and some adhesive is showing, so it had to go.
This exposed the interior, which represents the Director's Saloon complete with home comforts, artworks, plush seating, food, drinks, and lighting (non working). There is a private toilet towards the front (not detailed) and other little luxuries. It was made so the glazing is removable and I will replace that too. This has allowed me to photograph through the window aperture and gives views not usually accessible......
IMG_7515.JPG
IMG_7515.JPG (109.39 KiB) Viewed 5527 times
IMG_7516.JPG
IMG_7516.JPG (117.99 KiB) Viewed 5527 times
IMG_7510.JPG
IMG_7510.JPG (108.36 KiB) Viewed 5527 times
IMG_7519.JPG
IMG_7519.JPG (105.22 KiB) Viewed 5527 times
IMG_7521.JPG
IMG_7521.JPG (110.93 KiB) Viewed 5527 times
IMG_7510.JPG
IMG_7510.JPG (108.36 KiB) Viewed 5527 times
I am in the process of making a new roof as well as fitting a second motor bogie to the rear of the carriage. I found that the Lima motor bogie, under the tender, is not powerful enough to move the model, even though it was sufficient on the indoor layout. However, I have had to make changes to it from track power to 12v battery housed in a trailing wagon, thereby adding weight.
More to follow.

Re: Time to build a railway...but where?

Posted: Wed Jul 15, 2020 12:28 am
by LNR
I like the convex curves on the lower sections of the coach body, not easy to build like that I would of thought. Nice build inside as well.
Grant.

Re: Time to build a railway...but where?

Posted: Wed Jul 15, 2020 8:19 am
by ge_rik
Another masterpiece, Peter. I don't recall having seen this one before.

A Director's Saloon is on my to-do list, but I doubt mine (when I get around to it) will be anywhere near as elaborate. I can blame the impecunious state of the PLR finances .....

Rik

Re: Time to build a railway...but where?

Posted: Wed Jul 15, 2020 9:32 am
by FWLR
Superb Peter. That's a winner in anyones book. :thumbright:

Love the cream buns by the way... :lol:

Re: Time to build a railway...but where?

Posted: Thu Jul 16, 2020 7:42 am
by ge_rik
BTW Peter
Are the details dolls house accessories, charity shop finds or have you sculpted them yourself? The bust of Queen Victoria is particularly impressive.

Rik

Re: Time to build a railway...but where?

Posted: Thu Jul 16, 2020 9:45 am
by Peter Butler
Thanks again for the kind words..... In answer to Rik's question, most of the interior fittings are from dolls house suppliers, including the window blinds and cushion covers.... wall-paper. The wall mounted light fittings are from a small scale steam carriage model, and the rear windows are 'N' scale church window frames in white-metal.
If it looks about right, use it!

Re: Time to build a railway...but where?

Posted: Thu Jul 16, 2020 11:40 am
by invicta280
Its a charming item of rolling stock. Impressed by the elaborate curved sides.
The bust of good Queen Vic perched on the shelf is a testiment to the quality of trackwork on your line!

Re: Time to build a railway...but where?

Posted: Thu Jul 16, 2020 1:40 pm
by ge_rik
Peter Butler wrote: Thu Jul 16, 2020 9:45 am Thanks again for the kind words..... In answer to Rik's question, most of the interior fittings are from dolls house suppliers, including the window blinds and cushion covers.... wall-paper. The wall mounted light fittings are from a small scale steam carriage model, and the rear windows are 'N' scale church window frames in white-metal.
If it looks about right, use it!
Thanks Peter. I think it's your attention to detail which I really admire, not to mention your skill in constructing your creations. Somehow you have a knack of bringing everything together in a way which works - I'd say it's a balance between artistic flair and technical ability - plus, presumably, a fair bit of sheer effort.

Rik

Re: Time to build a railway...but where?

Posted: Mon Jul 20, 2020 11:43 pm
by Peter Butler
The Director's Saloon is now back in service and working far better than anticipated. The addition of a second Lima motor bogie unit has made all the difference, it is certainly more powerful but also smooths out the running characteristics. It is also very quiet.
I made a support cradle from Meccano to attach the unit from below the floor, having first cut out a section to allow it to fit inside the carriage.....
IMG_7525.JPG
IMG_7525.JPG (97.73 KiB) Viewed 5199 times
IMG_7523.JPG
IMG_7523.JPG (81.69 KiB) Viewed 5199 times
IMG_7524.JPG
IMG_7524.JPG (93.45 KiB) Viewed 5199 times
The new roof is now permanently attached and looks so much better.....
IMG_7530.JPG
IMG_7530.JPG (167.88 KiB) Viewed 5199 times
IMG_7531.JPG
IMG_7531.JPG (172.51 KiB) Viewed 5199 times
A third motor is also fitted to drive the flywheel, which rotates in the direction of travel when the Saloon is in motion. The linkage for this is via Delrin chain and sprockets to a home-made crank shaft and slide valves.....
IMG_7532.JPG
IMG_7532.JPG (130.52 KiB) Viewed 5199 times
Finally, being converted to on-board battery power, I needed a switch and charge socket, which are mounted between the loco and carriage, so not too visible.....
IMG_7534.JPG
IMG_7534.JPG (124.2 KiB) Viewed 5199 times
Well, it makes me happy!

Re: Time to build a railway...but where?

Posted: Tue Jul 21, 2020 12:26 am
by LNR
Peter Butler wrote: Mon Jul 20, 2020 11:43 pm Well, it makes me happy!
And so it should Peter, enjoyed the close-up of the steam cylinders and motion. It would have been fun putting all that complication together. The new roof certainly accentuates the coaches very crisp lines.
Grant.

Re: Time to build a railway...but where?

Posted: Tue Jul 21, 2020 8:06 am
by FWLR
I would be happy also Peter. You say it runs a lot more smoothly with the second motor, does that mean two motors are now powering the coach, or is one in the loco. Sorry for being stupid and asking want for some is simple for them, but for me I haven't been into modelling has long as most members and I am learning all the time.
Another thing is, I didn't know Lima were suitable for 32mm gauge ?

Re: Time to build a railway...but where?

Posted: Tue Jul 21, 2020 9:04 am
by ge_rik
Each new photo reveals yet more detail - eg the surfaces on the steps and the tiny crest on the side of the coach. Stunning!
A neat solution to the problem of being under powered. You must have a secret stash of Lima motor blocks.

Rik

Re: Time to build a railway...but where?

Posted: Tue Jul 21, 2020 11:07 am
by Peter Butler
Thanks again for your comments, I have to admit I have now started to enjoy this vehicle again after losing interest previously because of its problems. I first thought of building a powered, motorised truck to push it along, but that would have looked ungainly.
As I knew the roof was only part of my concern with it, I thought I should do a proper job, hence the surgery!
Fortunately, I had a Lima motor bogie ( Rod.... these are built for 7mm scale '0' gauge, so fit our 32mm track) This, however, is my last and I know how hard they are to find these days.
The two powered bogies are wired together, one at the rear, the other positioned underneath the tender, both pivot. The carriage is also articulated to the locomotive, so will happily take on all track conditions.
Rik.... I do like adding little details to my builds, but I think is is important to know when to stop, it can easily go too far!

Re: Time to build a railway...but where?

Posted: Wed Jul 22, 2020 8:13 am
by FWLR
Drat...I had the chance of buying 4 in January but when I was told they were Lima/Hornby I thought they were oo..... :(

Re: Time to build a railway...but where?

Posted: Wed Jul 22, 2020 10:44 am
by Peter Butler
FWLR wrote: Wed Jul 22, 2020 8:13 am Drat...I had the chance of buying 4 in January but when I was told they were Lima/Hornby I thought they were oo..... :(
Rod, if 'Hornby' was mentioned they probably were '00'. Also, if the price sounded reasonable they were unlikely to be Lima... they are quite expensive now.

Re: Time to build a railway...but where?

Posted: Wed Jul 22, 2020 9:17 pm
by steamyjim
A cracking model Peter - really love unusual stuff like that!

Have you a video of it in operation?

Re: Time to build a railway...but where?

Posted: Wed Jul 22, 2020 10:23 pm
by Peter Butler
I fear no video has been taken of this locomotive, as when Rik kindly filmed the last video here it was out of favour for not working satisfactorily.
I hope that when Rik visits next time (?) he can include all the new locos and rolling stock, which have increased quite dramatically during lock-down, and soon there will be more!
The unusual ones are definitely my personal favourites too.

Re: Time to build a railway...but where?

Posted: Thu Jul 23, 2020 5:27 am
by FWLR
Peter Butler wrote: Wed Jul 22, 2020 10:44 am
FWLR wrote: Wed Jul 22, 2020 8:13 am Drat...I had the chance of buying 4 in January but when I was told they were Lima/Hornby I thought they were oo..... :(
Rod, if 'Hornby' was mentioned they probably were '00'. Also, if the price sounded reasonable they were unlikely to be Lima... they are quite expensive now.
Good job I didn't buy them then Peter. Thanks for the information also mate. See how little I know on modelling.... :roll: :roll: