After seeing a post by philipy where he mentioned Repetier-Host in https://gardenrails.org/forum/viewtopic ... 1&start=20 (Nov 13 2023) I became curious about what it was.
I had a quick read of the blurb on the Repetier website about Repetier-Host and it looks like it is all an singing all dancing piece of software.
The impression I get is that it could perhaps allow me to replace my Cura slicer (Cura Engine is built in)and Octoprint using Repetier-Server.
This may be worth further investigation.
Using Repetier-Host
- GAP
- Trainee Driver
- Posts: 691
- Joined: Sun Dec 23, 2012 10:34 pm
- Location: Bundaberg QLD Australia
- Contact:
Using Repetier-Host
Graeme
From the home of the Ringbalin Light Railway
https://ringbalin-light-railway.blogspo ... -page.html
From the home of the Ringbalin Light Railway
https://ringbalin-light-railway.blogspo ... -page.html
Re: Using Repetier-Host
Yep it does appear to do all sorts, but I've never really investigated, I only ever use it for it's repair ability. .Do a drawing -> export stl--> run it through Repetier, -->re export stl --> transfer to slicer. I do the same routine for both resin and fdm, but obviously use either Chitubox or Cura as appropriate.
Philip
Re: Using Repetier-Host
I'm not sure that Repetier can do what you are asking but there was a thread which included this subject, not too long ago. https://gardenrails.org/forum/viewtopic ... ri#p173710lisamerlot wrote: ↑Sun Dec 31, 2023 9:28 pm With that program are you able to take photos of people and use it to produce miniature figures for a railway set? Has anyone ever done that on here? Would be interesting to know if it can be done.
Lisa
Philip
Who is online
Users browsing this forum: No registered users and 1 guest