Bearings
Bearings
Can anyone help me with finding where I can buy these from please. I print my own chassis, but I need the top hat bearings for them.
They are the standard size 3mm o/d.
Thanks guys.
They are the standard size 3mm o/d.
Thanks guys.
ROD
Life is so easy when I run my trains.
https://gardenrails.org/forum/viewtopic ... 41&t=11364
https://www.youtube.com/@fairywoodlightrailway
Life is so easy when I run my trains.
https://gardenrails.org/forum/viewtopic ... 41&t=11364
https://www.youtube.com/@fairywoodlightrailway
Re: Bearings
I've been using these. They come in a packet of 8 and they are cheaper than any I've found advertised for railways - these are intended for road vehicles but are 3mm bore which is the important bit. They are slightly longer but that's easily trimmed off if you need to.
https://www.ebay.co.u/itm/114313789511
Full length on the left, and trimmed on the driven axle
https://www.ebay.co.u/itm/114313789511
Full length on the left, and trimmed on the driven axle
Philip
Re: Bearings
I got some from Essel Engineering.
I wanted 4mm bore which aren't listed on his website but he said that as he makes them himself he can make them to any size.
Rik
I wanted 4mm bore which aren't listed on his website but he said that as he makes them himself he can make them to any size.
Rik
Re: Bearings
Thanks Phillip and Rik. That is brilliant info.
Never lets me down this forum. Someone will always come up with a brilliant answer.
Never lets me down this forum. Someone will always come up with a brilliant answer.
ROD
Life is so easy when I run my trains.
https://gardenrails.org/forum/viewtopic ... 41&t=11364
https://www.youtube.com/@fairywoodlightrailway
Life is so easy when I run my trains.
https://gardenrails.org/forum/viewtopic ... 41&t=11364
https://www.youtube.com/@fairywoodlightrailway
Re: Bearings
Rod, I've just looked again at the photo in your original post and realised that you are showing an outside diameter on the bearing of 2.99mm, which presumably means you want a 2mm bore, not 3mm? In which case of course, my suggestion is wrong, my apologies.
The outside diam. is only semi-relevant, it's the axle diameter/bearing bore which are important.
The outside diam. is only semi-relevant, it's the axle diameter/bearing bore which are important.
Philip
Re: Bearings
Thanks Phillip. Not to worry, it's an easy mistake to make.
I do it all the time.
I do it all the time.
ROD
Life is so easy when I run my trains.
https://gardenrails.org/forum/viewtopic ... 41&t=11364
https://www.youtube.com/@fairywoodlightrailway
Life is so easy when I run my trains.
https://gardenrails.org/forum/viewtopic ... 41&t=11364
https://www.youtube.com/@fairywoodlightrailway
Who is online
Users browsing this forum: No registered users and 0 guests