Page 2 of 2
Re: Summertime, and your printer's seem idle?
Posted: Mon May 23, 2022 6:47 pm
by -steves-
OK, wrapped up, hopefully being collected tomorrow, so should be with you on Thursday.
A few little extra bits in there, hope you can make use of them.
Re: Summertime, and your printer's seem idle?
Posted: Tue May 24, 2022 12:07 am
by Phil.P
Intriguing...
Re: Summertime, and your printer's seem idle?
Posted: Thu May 26, 2022 3:15 pm
by Phil.P
Post has arrived...
Stern looks, from Domestic Authorities..
One parcel from Peter Binnie. - Strange! I seem to have ordered four chassis.
So now I have the major components of three 'Windy'..
Steve, thank you for the other bits and pieces. They raise a number of questions, but probably for a different time and place?
(But did you intend to drop a motor in the box?)
The power of the Community, wins again.
Another 'thank you' to you both.
Phil Partridge.
Re: Summertime, and your printer's seem idle?
Posted: Thu May 26, 2022 6:23 pm
by -steves-
Phil.P wrote: ↑Thu May 26, 2022 3:15 pm
Post has arrived...
Stern looks, from Domestic Authorities..
One parcel from Peter Binnie. - Strange! I seem to have ordered four chassis.
So now I have the major components of three 'Windy'..
Steve, thank you for the other bits and pieces. They raise a number of questions, but probably for a different time and place?
(But did you intend to drop a motor in the box?)
The power of the Community, wins again.
Another 'thank you' to you both.
Phil Partridge.
Yes, I have loads and loads of motors and I just wanted to make sure you had something that fitted, it's a 3v-6v motor.
Hopefully all of the contents was useful?
Re: Summertime, and your printer's seem idle?
Posted: Thu May 26, 2022 8:31 pm
by Phil.P
Yes, thank you..
Payment made.
Thanks again Steve,
Phil.
Re: Summertime, and your printer's seem idle?
Posted: Thu Jun 09, 2022 10:06 am
by Phil.P
For anyone Vaguely interested:
The 'quick' distraction-project, has grown wings (propellers?)..
The performance (on a windy day, and roughly thrown-down track) was disappointing.
The wind blew 'Windy' backwards, and there was not enough 'oomph' to get up the slopes..
The Tamiya liquid cement, doesn't seem to work-well, with Binnie plastic. - Axle-boxes fell off, but that is good, as I am hunting for metal wheel-sets.
Flanged bearings, are on their way from the USA..
The hunt for a commercial propeller, continues..
No pictures, until I have something running better. - I am not going to paint, until I know if I am going to have to chop things about..
Phil.P