Re: PLA curling at the nozzle
Posted: Thu Oct 28, 2021 9:04 pm
Mine has a rubber boot covering the majority of the nozzle that has to be removed to get at the nut part, only accessible after removing cover.-steves- wrote: ↑Thu Oct 28, 2021 6:58 pmThat's odd, on all my Enders I just use the spanner straight on nozzle, I don't have to take anything off?GAP wrote: ↑Wed Oct 27, 2021 9:27 pmI pulled the filament out before pushing the wire up, nozzle at 200C then I replaced the filament and hand fed a large amount through the nozzle to clear it.
I will look at the nozzle again to see if I can get it out without breaking anything, the mount feels flimsy plus I have to remove the fan and cover to get at the nozzle.
Picture from earlier post on page 2