Laser cut copper platework for project boiler
Posted: Sat Mar 27, 2021 8:43 am
I recently had some bits for my g1 project loco’s boiler laser cut, due to minimum order requirements I have some spares so thought id see if anyone wants them.
Smokebox throat plate is sized for a 2” 20 gauge barrel, flue tube is 3/4” and the other 2 holes are 1/4”.
Throat plate is sized as per book drawings, again 3/4” hole.
Backhead is oversize for 2” barrel, with a 4mm guide hole at the top, 1/4” holes to match the smokebox end and 2 5/16”holes for bushes.
I’m after £10 posted (in the uk) per set. Any questions just ask!
It’s crossed my mind that they could be used to build a meths or maybe coal fired boiler for a lady Anne or similar...
Smokebox throat plate is sized for a 2” 20 gauge barrel, flue tube is 3/4” and the other 2 holes are 1/4”.
Throat plate is sized as per book drawings, again 3/4” hole.
Backhead is oversize for 2” barrel, with a 4mm guide hole at the top, 1/4” holes to match the smokebox end and 2 5/16”holes for bushes.
I’m after £10 posted (in the uk) per set. Any questions just ask!
It’s crossed my mind that they could be used to build a meths or maybe coal fired boiler for a lady Anne or similar...