Page 1 of 1
Weebee Safety Valve Cover
Posted: Fri Apr 17, 2020 10:52 pm
by IanC
Does anyone know if anyone makes a cover for the Weebee safety valve?
Thanks in advance.
Re: Weebee Safety Valve Cover
Posted: Sat Apr 18, 2020 6:54 am
by tom_tom_go
You can use your existing safety valve bonnet by fitting a brass collar around the safety valve that matches the ID of the safety valve bonnet.
I had one fitted to my Riverdale boiler using the Roundhouse cover. When you order the valve from TTD ask them to supply a collar for your engine.
Re: Weebee Safety Valve Cover
Posted: Sat Apr 18, 2020 11:04 am
by IanC
tom_tom_go wrote: ↑Sat Apr 18, 2020 6:54 am
You can use your existing safety valve bonnet by fitting a brass collar around the safety valve that matches the ID of the safety valve bonnet.
I had one fitted to my Riverdale boiler using the Roundhouse cover. When you order the valve from TTD ask them to supply a collar for your engine.
Thanks Tom,
The Weebee is already fitted with a collar. Simon at Anything Narrow Gauge fitted it. However the collar is larger than the old valve body. The old valve body had only a few thou clearance. I 'll see if someone with access to machine tools can open out the diameter to a depth of about 3mm. Should do the trick I think?
Re: Weebee Safety Valve Cover
Posted: Sat Apr 18, 2020 12:39 pm
by tom_tom_go
I would ask Simon to adjust it for you as he fitted it.
Re: Weebee Safety Valve Cover
Posted: Sat Apr 18, 2020 9:32 pm
by IanC
There's nothing wrong with the safety valve. The old cover is at fault. It was designed to fit the Accucraft safety, not the Weebee which is a different design and has different dimensions. There is a recess in the old cover which is not deep enough. I'll speak to Simon though to see what he can suggest.