Maximum voltage ?

Do you have a problem? Here is the place to appeal for help
Post Reply
Bandit

Maximum voltage ?

Post by Bandit » Wed Oct 23, 2013 12:57 pm

Hello there!
Could you tell me the maximum voltage for the little HGLW motor ?
Thanks for your help.

dhippey

Re: Maximum voltage ?

Post by dhippey » Wed Oct 23, 2013 1:25 pm

The motors we supply are rated at 3v DC
However they will operate on 1.5v and up to 6v, but you risk damaging them over time.

The max I would suggest if you are wanting to r/c the loco is 4.5v

Finally, just in case you do damage the motor I stock replacements of course

Regards,
David H.
www.hglw.co.uk

Bandit

Post by Bandit » Wed Oct 23, 2013 1:27 pm

Thanks David.
Last edited by Bandit on Wed Oct 23, 2013 3:58 pm, edited 1 time in total.

jay1976

Post by jay1976 » Wed Oct 23, 2013 2:34 pm

maplins sell 6 and 12volt motors the same.. I just put a resistor from the speed controller so I dont accidently over volt the motor.. or just set max speed with controller..

MDLR

Post by MDLR » Wed Oct 23, 2013 3:29 pm

The Rat has a 3 volt motor running on 4.5 volts - goes OK......................

Post Reply

Who is online

Users browsing this forum: No registered users and 20 guests