Morning all,
I am going to remove the cranks and conrod off my Bulldog loco. Was just wondering if the screws holding cranks in place need screw lock or are just tightened up as they are.
Thanks Alan.
Roundhouse cranks
- tom_tom_go
- Driver
- Posts: 4824
- Joined: Wed Feb 23, 2011 3:08 am
- Location: Kent, UK
- Contact:
Re: Roundhouse cranks
When you take them off you will see if any Loctite has been applied.
-
- Trainee Fireman
- Posts: 116
- Joined: Mon Mar 26, 2012 4:00 am
- Location: Wodonga, Vic. Land of Oz
Re: Roundhouse cranks
Hi graff,
Belt & braces approach is always good, just make certain you use the right type of loctite!
Tim
Belt & braces approach is always good, just make certain you use the right type of loctite!
Tim
Re: Roundhouse cranks
Hi All,
Thanks for advice given. I checked the screws and found no trace of loctite, so,reassembled the cranks etc without loctite. They are nice and tight, but I will keep an eye on them in case they loosen.
Regards Alan.
Thanks for advice given. I checked the screws and found no trace of loctite, so,reassembled the cranks etc without loctite. They are nice and tight, but I will keep an eye on them in case they loosen.
Regards Alan.
Who is online
Users browsing this forum: No registered users and 8 guests