Page 1 of 1
Tenmille slide chairs
Posted: Sun Jun 19, 2022 6:31 pm
by jefran
In the 1990s I made a drilling jig for 8'-0" radius points using Tenmille chairs, and last year I used it again to make a couple of points for the loop of the revived line. Slide chairs seemed to be out of stock everywhere, but I found a pack on Ebay and used them. Now I want to add some sidings and need some more slide chairs; they are either out-of-stock again, or still out-of-stock. Can they be had, or is there another solution I haven't thought of? The obvious thing is to cut the inner jaw off the standard chair, but I am not sure that it would support the rail at the full movement of the points, or at least with the levers that I have seen.
Re: Tenmille slide chairs
Posted: Sun Jun 19, 2022 10:08 pm
by Peter Butler
Is this what you are looking for, if so, how many?
- IMG_8996.JPG (54.47 KiB) Viewed 3828 times
Re: Tenmille slide chairs
Posted: Sun Jun 19, 2022 10:19 pm
by jefran
Those are exactly what I need! I think that I can manage with 4, if that is possible - thank you.
Re: Tenmille slide chairs
Posted: Sun Jun 19, 2022 10:24 pm
by Peter Butler
PM sent.
Re: Tenmille slide chairs
Posted: Tue Jun 28, 2022 10:02 pm
by jefran
Thanks to some generous help from Peter Butler the points are now complete and I am in the process of installing them
Re: Tenmille slide chairs
Posted: Tue Jun 28, 2022 10:22 pm
by Peter Butler
Lovely job, very tidy.
Re: Tenmille slide chairs
Posted: Wed Jun 29, 2022 3:26 pm
by ge_rik
They do indeed look top notch
Rik
Re: Tenmille slide chairs
Posted: Tue Jul 05, 2022 11:23 am
by jefran
Thank you, though I am sure that the scale of notches extends beyond this. The installation is now complete, though the operating linkages are temporary. The picture shows the installation and what may become the line's longest loco running clearance trials
- 2022_0704Immidge0002.JPG (2.33 MiB) Viewed 3561 times