Page 1 of 1

Waterproofing 3D prints

Posted: Sat Nov 09, 2024 7:45 am
by GAP
This video is by a pack of nerds who make submersible drones.

The thing that peaked my interest was a reference to a product called "Dichtol" that a model is soaked in to fill all the voids in the model that let water ingress in.
https://www.amazon.com.be/-/en/DIAMANT- ... B0C4YZ99PJ

Unfortunately I cannot find it in Aust

Re: Waterproofing 3D prints

Posted: Sat Nov 09, 2024 8:22 am
by philipy
GAP wrote: Sat Nov 09, 2024 7:45 am
Unfortunately I cannot find it in Aust
Not sure if this is exactly what you want but they are in Oz

https://www.metalspraysupplies.com/cons ... rs?start=1

Re: Waterproofing 3D prints

Posted: Sat Nov 09, 2024 9:18 am
by GAP
philipy wrote: Sat Nov 09, 2024 8:22 am
GAP wrote: Sat Nov 09, 2024 7:45 am
Unfortunately I cannot find it in Aust
Not sure if this is exactly what you want but they are in Oz

https://www.metalspraysupplies.com/cons ... rs?start=1
Thanks Philip I have contacted the company and will wait till they reply