First annoyance with 3D printing.
Posted: Tue Jan 26, 2021 6:37 pm
Printer expected today, 3 delivery vehicles pulled up outside our house with intent, I gets all excited waiting in the hall for the door to knock....and all 3 deliveries went elsewhere and I'm printlerless still.......Mrs is howling laughing
Anyhow it has to land tomorrow.
So back to 3D prining and in particular CAD, thought I'd start here as it's now in the correct part of the forum.
Had a week on Tinkercad now and as I said I rate it. Nowhere need up to speed but grasping basics and as stated it's far easier to just get on and build than 360 as you are not spending half your time wondering where some hidden feature is.
This is my first crappy attempt at a loco, I'll start the bottom half shortly.
I have saved all components as single items but just stitched this together as the nearly completed shell.
Very, very basic but it does seriously get you thinking and also helps in discovering new tricks every half hour.
Hoping to learn a heck of a lot more here...then maybe a good blast on 360.
Cheers guys
Kenny
Anyhow it has to land tomorrow.
So back to 3D prining and in particular CAD, thought I'd start here as it's now in the correct part of the forum.
Had a week on Tinkercad now and as I said I rate it. Nowhere need up to speed but grasping basics and as stated it's far easier to just get on and build than 360 as you are not spending half your time wondering where some hidden feature is.
This is my first crappy attempt at a loco, I'll start the bottom half shortly.
I have saved all components as single items but just stitched this together as the nearly completed shell.
Very, very basic but it does seriously get you thinking and also helps in discovering new tricks every half hour.
Hoping to learn a heck of a lot more here...then maybe a good blast on 360.
Cheers guys
Kenny