Page 1 of 1
anyone?
Posted: Sun May 03, 2009 12:30 am
by pauly
anyone here uses 1 of these?
Im very interested in getting 1 and building a shuttle line
http://www.timpdon.co.uk/timpdon/telec/ ... od_sh3.php
Posted: Sun May 03, 2009 8:39 am
by LMS-Jools
Looks interesting and of potential use to me too when I eventually build an end to end layout.
I look forward to seeing developments.
Posted: Sun May 03, 2009 10:25 am
by SillyBilly
I like it lots.
Posted: Sun May 03, 2009 6:41 pm
by SillyBilly
Andel had one on the stand at the Porthmadog show, I asked him about it for you Pauly and his comments were that aslong as you read the instructions and adhere to them and put the magnets in the right place it'll be fine.
Posted: Sun May 03, 2009 6:59 pm
by pauly
thanks SB
now I gotta figure out if it go into 1 of these wihout to much fuss
http://www.ipengineering.co.uk/page36.html
Posted: Sun May 03, 2009 11:43 pm
by SillyBilly
Probably if you do as Brian has done and put a load over the back to cover up any gubbins you put in there.
Reed Switches
Posted: Tue Oct 27, 2009 10:49 pm
by John Richards
Pauly,
I built one of those End too End Tracks for display at an Exhibition
over here in OZ quite some Years back!, I built Brass Model
Locomotives in all scales and Gauges for clients Worldwide!.
The biggest problem was my display was always Static, not very
eye catching at all, anyway, I used Two Reed Switches and Two
Small Magnets, That was it!.
I then added a passing loop which required Two more Magnets
and a DPDT switch, this sure raised the interest of the Pundits
at the Show!.
All up, this cost around $25.00 Au`
or about 13 quid in your
Foriegn currancy!.
Just another idea for you to Juggle!.
Good to see you here!,
John.