Lamps and Detailing

dougrail · Post by **dougrail** » Fri Aug 05, 2011 5:43 pm

I recently acquired a trio of lamps and some GRS frets off Ebay. I thought they were ornamental only and two of them were - white, roundhandle, one red, one white lens.

The third is a sleek black number with a working amber LED! And the whole set only cost me £12.

Now here's the problem.

I'd like to use a fret to hang a lamp off the smokebox of a Mamod-smoke-fitted locomotive. I initially thought epoxy might work, but the smokeboxes get hot and so the epoxy would likely run [very likely run!]

What do people suggest?

ALSO

I'd like to try and rivet-detail the same smokebox as there is no way in Hell noone would sell me an original IPE Jane smokebox seperately from their loco [and I must say I can't blame them!]

Is there any advice, suggestions or how-to to go about this without cutting said smokebox up?

Many thanks gents

MDLR · Post by **MDLR** » Fri Aug 05, 2011 7:07 pm

dougrail:57213 wrote:I'd like to use a fret to hang a lamp off the smokebox of a Mamod-smoke-fitted locomotive. I initially thought epoxy might work, but the smokeboxes get hot and so the epoxy would likely run [very likely run!]

What do people suggest?

I'd gently drill and tap the smokebox to take a suitably-sized BA bolt and attach the lamp iron thussly. The Roundhouse ones come with two holes.......... Do the GRS ones?

dougrail · Post by **dougrail** » Fri Aug 05, 2011 7:15 pm

They do have two holes...two extremely small holes. I also have no screws as such so small. :/

Sir Clothem Cap · Post by **Sir Clothem Cap** » Fri Aug 05, 2011 8:12 pm

Drill a very small hole and superglue a bent and cut down dressmaking pin to make a mounting.
For extra rivet heads cut some dressmaking pins heads off and superglue in position then add black paint to seal them in place.

dougrail · Post by **dougrail** » Sat Aug 06, 2011 12:18 pm

Thanks fior the advice SCC. I had considered superglue, but I also know that the Mamod/MSS smokeboxes get red hot in use - wouldn't this melt the glue?

Sir Clothem Cap · Post by **Sir Clothem Cap** » Sat Aug 06, 2011 6:52 pm

I don't think so I have used it to attatch thr black pump bit on my mamod on the smoke box casting without a poblem

dougrail · Post by **dougrail** » Sat Aug 06, 2011 7:37 pm

What superglue is it that you used then?

'Black pump thing'? A vaccuum hose perchance?

Sir Clothem Cap · Post by **Sir Clothem Cap** » Sat Aug 06, 2011 8:48 pm

the bit on the smokebox casting.

dougrail · Post by **dougrail** » Sat Aug 06, 2011 9:23 pm

Cheers for the photo.

That's a sandbox I think?

Sir Clothem Cap · Post by **Sir Clothem Cap** » Mon Aug 08, 2011 10:47 am

The sand box was put on by a previous owner to "narrow gauge" it more. it is riveted on but had become wobbly so a drop of superglue has fixed it.

Garden Railway Forum

Lamps and Detailing

Lamps and Detailing

Re: Lamps and Detailing

Who is online