Ringbalin Light Railway

[GAP]

Really coming along nicely!
I agree with Greg re the blog. Interesting detail on the RC system

Rik

Thanks Greg and Rik.
The RC system I found while looking for some parts, they are reasonably priced relative to others and I can get them readily plus the R/C gear from Hobby King is very keenly priced.

[GAP]

Work on the low trestle area has started.
A few pictures to show the work, I have put some stones and roughed in some turf to get a feel for what I am trying to do.
Blog to be updated.

Trestle area.JPG (186.1 KiB) Viewed 25666 times

Low Trestle bench work Lengthwise.JPG (203.91 KiB) Viewed 25666 times

Rocks roughed in.JPG (166.25 KiB) Viewed 25666 times

Mesh detail.JPG (190.54 KiB) Viewed 25666 times

Meadow bank roughed in.JPG (183.22 KiB) Viewed 25666 times

[philipy]

Using the chicken wire to support the stones to contour the slope/gap is a very clever idea, I do like that.

[GAP]

Using the chicken wire and mesh allows the rainwater to pass through and air to circulate, so hopefully there will not be any rot due to the timber staying wet.

[GAP]

I have updated my blog with another loco description.

[GAP]

As can be seen in a couple of pictures above, the high trestle developed a low spot centered on 1 bent, initial investigations suggested that the dodgy method of skew screwing the support board had failed.
Further investigations revealed that 2 of the 4 screws at the end of the baseboard and one on the bent support had been sheared possibly by something heavy landing on the trestle.
I suspect either next doors moggy or "old poss" the possum using the trestle as a pathway after jumping off the fence.
This has now been repaired so work is scheduled for the low trestle work to recommence.

Blatant blog advert; https://ringbalin-light-railway.blogspo ... -page.html
The blog has been updated to include descriptions of 2 more locos ( Side Rod and Sugar Cane), these ones have sound cards and motor delay so that the sound "Revs" build before the loco begins to move.
The delay is provided by running the throttle signal through a "Picaxe" microcontroller, sound input passes straight through but motor is delayed.
The sound cards are of a design dating back to the 1970's using discrete IC Shift Registers, these days the same could be achieved by microcontrollers.

[LNR]

I had the same problem with cats and possums, but an electric fence energizer from the farm has fixed that. I don't know if anything has received a boot from it, but as much as anything I think the click click sound as it discharges is keeping things away. As you sound like an electronics person, would an electronic clicker be worth a try.
Grant.

[GAP]

I had the same problem with cats and possums, but an electric fence energizer from the farm has fixed that. I don't know if anything has received a boot from it, but as much as anything I think the click click sound as it discharges is keeping things away. As you sound like an electronics person, would an electronic clicker be worth a try.
Grant.

The biggest problem with "old Poss" is that she and bub live in my roof space and I cannot get anyone to come and get them out.
Even if they are out of the roof they can't be relocated more than 50 Metres away (protected species).
My solution is to get a carpet python and shove it into the roof space but SWMBO has given an emphatic "NO!!!" to that suggestion.
There are a large number of fruiting palm trees on either side that provide year round food, but one neighbour is going to cut all his down sometime this year.
The electric fence idea may work near the railway but probably won't work anywhere else as "old Poss" jumps from the roof into the trees. El Moggo hopefully may get a zap which should deter it.
There are sonic devices that are used to keep possums away from garden beds, according to an expert I contacted, but who was to far away to help remove it, won't get them to move That may be an option as well.

[GAP]

The "Low" Trestle has been finished and baseboard either side installed.

Low Trestle Lengthwise.JPG (193.55 KiB) Viewed 27304 times

Low Trestle Lengthwise Track Roughed in.JPG (188.47 KiB) Viewed 27304 times

Low Trestle Lengthwise Track Roughed in 1.JPG (125.53 KiB) Viewed 27304 times

Baseboard Side Fence Lower.JPG (82.2 KiB) Viewed 27304 times

Baseboard Back Fence Lower.JPG (81.2 KiB) Viewed 27304 times

Blog will be updated later

[philipy]

Coming on well, it's a great feeling when you get on a roll!

Just a thought, if it were mine, I would be sooo tempted to fill in the triangle between the RH corner at the end of the low level section and the first angled board joint on the brown boards, just to make it 'flow' visually.

[tom_tom_go]

Having built a raised railway gaps are good for drainage.

[philipy]

Having built a raised railway gaps are good for drainage.

Agreed, but I was referring to the front tringle not the rear gap.

[GAP]

Having built a raised railway gaps are good for drainage.

Agreed, but I was referring to the front tringle not the rear gap.

If you are referring to the brown board at the front that was put in at the last minute because one of the trestle bents was sitting right on the edge.
It is still brown because that is the colour of the old deck that the boards came from and I could not paint it last night because it was going to rain.
The intention is to fill in the corner area with turf (the rocks that are there were just dumped there while I repaired the sunken bent and have not been returned to their place.
To add some interest I have a water tank that I am considering using in the upper area with a water bore, a pump house and a water spout in the lower area. The pump house will explain how the water got up to the upper level.

[GAP]

The blog for the low trestle has been updated

[GAP]

Work has progressed quite quickly thanks to COVID-19 isolation
The line on both the high and low trestle have been screwed down and the scenery underneath both has been finished.
I am still contemplating whether to put an edge on the high trestle or not, plus I am thinking about some sort of safety rail at the back to catch any rolling stock that may derail.
I am leaning toward the safety rail at the back but leaving the front as it is, a check rail is in the mix as well.

Trestles w-scenery.JPG (179.53 KiB) Viewed 26975 times

Trestles w-scenery (2).JPG (186.04 KiB) Viewed 26975 times

Rocky gully.JPG (163 KiB) Viewed 26975 times

Rocky gully w trestle.JPG (181.83 KiB) Viewed 26975 times

Rocky gully and paddock.JPG (199.46 KiB) Viewed 26975 times

[GAP]

Work continued on laying baseboards across the back fence on the lower level and down the side fence on both levels, the upper level across the bridge and along the back fence is next cab off the rank.

I am considering a temporary switchback so I can run a loco and a few wagons to do some testing/playing.
At the end of baseboards the track will loop back and do some sort of "S" to take it to a "Town" area to be built on table which of course has to be constructed.
After that getting a line back to the upper level from the "Town" is going to be an engineering challenge and there is of course the spur that will run into the shed leading to storage yards.

Across the back fence

Baseboard back fence.JPG (171.9 KiB) Viewed 26974 times

Down the side fence

Baseboard down hill side fence.JPG (192.82 KiB) Viewed 26974 times

Baseboard down hill side fence (2).JPG (182.55 KiB) Viewed 26974 times

What to do about disguising the level change to make it less visually obvious, possibly a stone cutting face?
Any thoughts welcome on that.

[Jimmyb]

What to do about disguising the level change to make it less visually obvious, possibly a stone cutting face?
Any thoughts welcome on that.

What about slate, vertically it will hide the gap and should whether nicely.

[GAP]

What to do about disguising the level change to make it less visually obvious, possibly a stone cutting face?
Any thoughts welcome on that.

What about slate, vertically it will hide the gap and should whether nicely.

Worth a thought

[ge_rik]

You could always try Bob Treat's approach to casting rock faces in concrete. That way you can tailor them to the location and being facades they would weigh considerably less than real rockwork.
https://familygardentrains.com/primer/r ... cliffs.htm

rocks_n_cliffs_big (1).jpg (165.44 KiB) Viewed 26922 times

.

mystic_stairs (1).jpg (386.93 KiB) Viewed 26922 times

.
Rik

[ge_rik]

There's a link to two downloadable .pdf documents on the site. One is all about concrete rock making and the other, by coincidence, is about trestles.....
http://tjstrains.com/request-pdfs/

Rik