Binnie Tub Body
Re: Binnie Tub Body
Doesn't look too bad. On my printer a little support would have helped, the print isn't clean underneath the curves.
I'll attack it with a file, sandpaper and primer later.
I'm also seeing if I can reliably print a chassis for it. It's on the printer at the moment!
I'll attack it with a file, sandpaper and primer later.
I'm also seeing if I can reliably print a chassis for it. It's on the printer at the moment!
Re: Binnie Tub Body
That does look great on the chassis. I can see that the two parts that came off my print does make it look like they should be there. Good job I kept them.....
Hope the chassis is also a success, then we have a lot of printing to do for a nice long train of them...
Hope the chassis is also a success, then we have a lot of printing to do for a nice long train of them...
ROD
Life is so easy when I run my trains.
https://gardenrails.org/forum/viewtopic ... 41&t=11364
https://www.youtube.com/@fairywoodlightrailway
Life is so easy when I run my trains.
https://gardenrails.org/forum/viewtopic ... 41&t=11364
https://www.youtube.com/@fairywoodlightrailway
Re: Binnie Tub Body
By the way I have slowed the speed down to 50 and layer height 0.10. I find that the slower speed and the fine layer height gives a better print, lot slower but worth it in the end I feel.
ROD
Life is so easy when I run my trains.
https://gardenrails.org/forum/viewtopic ... 41&t=11364
https://www.youtube.com/@fairywoodlightrailway
Life is so easy when I run my trains.
https://gardenrails.org/forum/viewtopic ... 41&t=11364
https://www.youtube.com/@fairywoodlightrailway
Re: Binnie Tub Body
I think I'm happy with it. I've posted it, but I feel I need one more print to be 100% happy. You have been warned
https://www.thingiverse.com/thing:4843877
https://www.thingiverse.com/thing:4843877
Re: Binnie Tub Body
Looks good that. Maybe I will wait though until you have done another print. Also can it be printed without the wheels. I like to use metal wheels, so no need to print them. I have downloaded the file but it will take over 5 hours to print, is that how long you print yours for...
ROD
Life is so easy when I run my trains.
https://gardenrails.org/forum/viewtopic ... 41&t=11364
https://www.youtube.com/@fairywoodlightrailway
Life is so easy when I run my trains.
https://gardenrails.org/forum/viewtopic ... 41&t=11364
https://www.youtube.com/@fairywoodlightrailway
Re: Binnie Tub Body
Agreed, about 4/5 hrs..
Just load it into tinker cad and delete my wheels..
It's on the printer, started about 8.30..
Just load it into tinker cad and delete my wheels..
It's on the printer, started about 8.30..
Re: Binnie Tub Body
Printed fine, 4.5hrs..
Who is online
Users browsing this forum: No registered users and 8 guests