New P-Way train for the FBGR

What is your latest project?
User avatar
Sir Clothem Cap
Driver
Driver
Posts: 1707
Joined: Sun Sep 26, 2010 8:45 pm
Location: Hampshire
Contact:

Post by Sir Clothem Cap » Sun Mar 11, 2012 9:54 am

Well done JOhn your painting is an inspiration.

User avatar
FBGR
Trainee Fireman
Trainee Fireman
Posts: 171
Joined: Thu Sep 08, 2011 10:17 pm
Location: South Hampshire

New P-Way train for the FBGR

Post by FBGR » Sun Mar 11, 2012 11:18 am

Here are the three new skips, ready to go into the 'paintshop'
12 Mar 11 3 skips unpainted.jpg
12 Mar 11 3 skips unpainted.jpg (104.13 KiB) Viewed 3856 times
I think that will be the total of wagons for the new train for the time being, doing the same wagons several times I'm just about skiped out.

Hopefully, if there is good weather, and I finish the painting, we shall have a first running of the complete new train next week-end.

I don't know if I am going to be able to fix the Ruston loco by then - the motor has come loose in the chassis and there is fault (dry joint?) in the wiring somewhere.

JOhn
Last edited by FBGR on Fri Jun 30, 2017 10:10 pm, edited 1 time in total.

User avatar
FBGR
Trainee Fireman
Trainee Fireman
Posts: 171
Joined: Thu Sep 08, 2011 10:17 pm
Location: South Hampshire

New P-Way train for the FBGR

Post by FBGR » Sun Mar 18, 2012 6:34 pm

New train tested today -
12 Mar 18 New train a.jpg
12 Mar 18 New train a.jpg (160.4 KiB) Viewed 3856 times
The little old Ruston (built 2004 / 3 volts / only one axle driven / plastic wheels) managed the 16 axles, although did slow down a bit around our 1.5 metre (5 feet) radius curves. It is a little unwell in the wiring department so may be rebuilt with a new chassis soon.

The load on the bogie (last) wagon was only temporary, and I am making some bits and pieces to form a permanent (fixed) load.

I thought that I would have to add some more weight to the skips to stop them pulling over on the curves (they only have a small strip of lead under the middle channel), but they ran without any trouble.

I am a little unhappy with the finish to these skips, so these are going back into the paint shop.

JOhn
Last edited by FBGR on Fri Jun 30, 2017 10:07 pm, edited 1 time in total.

User avatar
90733
Driver
Driver
Posts: 1954
Joined: Wed Dec 16, 2009 6:17 pm
Location: West Yorkshire
Contact:

Post by 90733 » Sun Mar 18, 2012 7:49 pm

They are mighty impressive!
Thanks
Jack

User avatar
Sir Clothem Cap
Driver
Driver
Posts: 1707
Joined: Sun Sep 26, 2010 8:45 pm
Location: Hampshire
Contact:

Post by Sir Clothem Cap » Thu Mar 22, 2012 9:36 am

Fantastic JOhn Well done.

User avatar
FBGR
Trainee Fireman
Trainee Fireman
Posts: 171
Joined: Thu Sep 08, 2011 10:17 pm
Location: South Hampshire

New P-Way train for the FBGR

Post by FBGR » Fri Apr 06, 2012 1:46 pm

Here is the loaded rail wagon, so far.
12 Apr 06 loaded bogie.jpg
12 Apr 06 loaded bogie.jpg (111.84 KiB) Viewed 3856 times
Basically I have just added (glued on) a few 'rails' and a grease tub. A few more items, like chains, fishplates and bits & peaces may be added later, but that will do for now.

Next running session planned for tomorrow, as well as discussions as to the next project.

JOhn
Last edited by FBGR on Fri Jun 30, 2017 10:04 pm, edited 1 time in total.

User avatar
andysleigh
Driver
Driver
Posts: 1362
Joined: Thu Oct 18, 2007 6:21 pm
Location: Guildford
Contact:

Post by andysleigh » Fri Apr 06, 2012 6:21 pm

brilliant work! keep it up
Image

Post Reply

Who is online

Users browsing this forum: No registered users and 7 guests